Steering Rack Boot

A multi-fitting steering rack boot that fits the vast majority of car, SUV and light commercial applications whilst saving time and reducing risk.

The design includes a balance pipe connection. It can be used on both manual and power steering racks.

The integrity of steering rack boots is checked as part of the MOT test.

With limited access due to ever tighter packaging of engine bays, the steering rack boots are either exposed to greater heat and/or greater abrasion than before.

The widespread use of power steering racks adds to the wear rate.

You can install them without removing the track rod end.

Think of the time saving......

No struggling to free the locking nut. No sweating over the accuracy of the re-tracking equipment.

Easier > quicker > more profit.

The boots are very durable and highly elastic, made from a fully synthetic rubber, Cholorprene.

By splitting the track rod end you can fit the boot over the track rod using the cone and lubricant provided. Trim the boot to fit both rack and rod diameters. Secure both ends using our stainless-steel Omega clamps.

The garage benefits from the ease of fit and the customer gets a premium quality repair.

• Range of fit:
  small end 12mm - 42mm
  large end, 32mm - 65m
• Each kit contains:
  Rack boot
  3 alternative clamp sizes
  Sachet of lubricant
  Plastic bung.

One cone per carton

• UNIRACK_2     Pair of rack boot kits
• UNIRACK_4     4 rack boot kits
• UNIRACK_6     6 rack boot kits